IFish Fishing Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
13,100 Posts
Discussion Starter · #1 ·
I have had some request for a rod building class recently, and have finally found some time to put on a class. I have room for a couple more people in Wednesdays class. Class runs from 6pm to about 10pm. I will spend some time talking about blanks and components and the tools to build a rod. I will show you how to install a cork handle and reel seat, lay out the guides, tie guides, apply finish, and demonstrate how to tie a butt wrap (ie. diamond and/or chevron). At the end of class you should have enough knowledge to build your own custom rod.

Here is a link to my website discussing the rod building class LINK

If you wish for me to reserve you a spot in class please email me, and I will get you the address. Class will be in Milwaukie near the GI Joes on McLoughlin.

My email address is [email protected] to reserve your spot in class.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top