IFish Fishing Forum banner
1 - 1 of 1 Posts

·
Banned
Joined
·
37,111 Posts
BOE has the answer. You use a spinner maker. Too difficult to describe here fully but: You use one size larger gauge wire than you will use on the spinner, make a loop as normal then twist the wire back down the shank about 6 times, cut the loop off and pull the center wire out which leaves you with the twisted wire and tail end.

You use the tag end to come back up and around the twisted section kinda like a safety pin. Voila! Clevis. You slide the smaller gauge wire that will be the spinner wire through the twisted wire. Since the twisted wire was made of larger gauge, the hole through the middle is large enough to allow the clevis to spin on the smaller wire. Build the spinner, then add or change the blade.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top