IFish Fishing Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
846 Posts
I would mosey out to Cornelius and look up the parts guy at Western States Fire Apparatus. They have lots of aluminum in stock including diamond plate. They'll also cut and form whatever you want. Take the measurements and maybe a rough sketch
 

·
Registered
Joined
·
177 Posts
I see you are from Clackamas area.
There is a scrap yard on Evelyn st right near or at the Riverside park street turn. I just did this to my boat and picked up some 1/4" scraps for real cheap.
 

·
Registered
Joined
·
12,186 Posts
TB,
How much do you need? I have some 1/4" alum. sheet scrap around my shop, I might be able to be pursuaded to toss some your way in exchange for good fish Kharma.
GBS

[ 05-08-2003, 07:28 AM: Message edited by: greenbuttskunk ]
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top