IFish Fishing Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
339 Posts
Discussion Starter · #1 ·
I'm finally ready to upgrade to a bigger boat. I am looking at used 20' Asaltor on a galvenized trailer. The boat looks to be in decent shape, but has seen salt a few times every year (owner claims he always flushed the engines afterwards). Is there anything in particular I should be looking for in terms of damage/corrosion? Any tell-tale signs (for the hull, motor, or trailer)? Do I need to get a 3rd party to look it over? If so any recommendations?

BTW, I am already a boat owner but I bought my current boat new.

Also, while I'm soliciting opinions - is a 130hp Yami (2str) enough motor for this boat?

Thanks in advance,
Matt

[ 09-04-2003, 04:02 PM: Message edited by: grumman16 ]
 

·
Registered
Joined
·
339 Posts
Discussion Starter · #7 ·
Thanks for the input everyone. I think I'm just going to test drive it and make sure it slides into the garage - if both of these check out then I'll pull the trigger. I've looked it over a couple of times real good and other than a few salmon blood stains it looks to be extremely clean.

Will post a pic once I get possesion.

-G16
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top