IFish.net banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4,737 Posts
Discussion Starter #1 (Edited)
Service bulletin from NR Boats says that the fix for the erroding brass plugs is very simple. Tap the 1" schedule 80 drain tube with a 3/4" NPT tap and install a 3/4" aluminum pipe plug. Plug should only screw in 2/3 of the way don't tap too deep. They also suggets using 592 Loctite sealer and letting that cure 12 hours before wetting. Sounds like a good and simple cure to me. mThis could work for most all brand X boats as well providiing the use 1" schedule 80 tube.:bnews:
 

·
Registered
Joined
·
4,385 Posts
Sounds like the safest way to go if you're going to leave your boat moored. I keep mine on the trailer and like the removable plug.
 
1 - 2 of 2 Posts
Top