IFish Fishing Forum banner

Drift Boat floors

5K views 10 replies 9 participants last post by  diamondfish 
#1 Ā·
Right now I have the standard "strip floor" in my drift boat. The floor is pretty worn down, and I don't like how the water pools up where I keep some of my gear. I am looking into building a full width floor for my boat. I want something that is lightweight and non-reflective. What kind of options do I have? Also about what would the aluminum cost to do a 16*54 boat if I were to go that route? And what would be the best coating to put over a diamond plate aluminum floor?

Thanks,
Danny
 
#5 Ā·
Good Times, what did Willie charge? Did you have to tear out the old flooring or was that part of the deal? I have a 16 x 54 Willie with wood floors covered with some type of material and have been givng some thought to going with the diamond plate. Thanks.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top