Help with Miller Marine Anchor nest

#1 Okie · 04-13-2007, 09:52 AM

I recently had a Miller Marine anchor nest installed on my SuperV. It works great with rocker and paramid anchors as well. The problem I have is to install it my Jamb cleat had to be removed. The miller takes up the hole area it is monted on with the chock just below it about an inch from the back end. This works perfect for tying off to the chock and the length of my anchor shaft is identical so it fits great for leaving it there in transit. Problem is that when fishing small rivers or lakes I like to use my Paramid anchor and like to be able to pull and set it from where ever in the boat securing it in a jamb cleat. With this anchor system I can't figure out a real good position to install a jamb cleat. Anyone have a good Idea to pass on? Thanks in advance for your help.

Tvfowlhunter · 04-13-2007, 10:24 AM

BUY A WILLIE PREDATOR!

your son,

Trent

#1 Okie · 04-13-2007, 10:38 AM

I'm not that desparate.

Gundog · 04-13-2007, 12:22 PM

Can you post a picture of the mounting and the area you have to work with? It is very possible the Anchor Locker could be moved further forward extending in front of the boat and freeing up some space to mount a clam cleat.
Mike

#1 Okie · 04-16-2007, 10:14 AM

I already looked at that option but am trying to figure out another route to do it. I'll try to get a picture posted asap. Thanks for your input.

marthagofish · 02-18-2012, 10:24 PM

Quote:

Originally Posted by #1 Okie

I already looked at that option but am trying to figure out another route to do it. I'll try to get a picture posted asap. Thanks for your input.

Where are the photos...