2003 8hp Merc prop?

[CCCatch]

I just purchased this used kicker. Everything checked out OK except the prop seems to slip along the hub gear about 1/4". My 25hp Merc has some play at the prop as well but not this much. I can actually see the internal gear from the gap between the prop and the casing. Is that normal? Thanks in advance.

[Boat Doc']

I just purchased this used kicker. Everything checked out OK except the prop seems to slip along the hub gear about 1/4". My 25hp Merc has some play at the prop as well but not this much. I can actually see the internal gear from the gap between the prop and the casing. Is that normal? Thanks in advance.

With the prop pushed forward you should not see a gap where it meets the gear housing. If so then something either isn't installed or something is badly worn

[CCCatch]

Thanks Doc. When pushing forward, it closes the gap and it looks normal like my 25hp Merc assembly. The gap shows only when I pull it back; it seems to have more play than my other motor.

Thanks fishkisser for the PM, I will check out the assembly to see if it is missing something or something is worn.

cccatch

[CCCatch]

Just want to share the learning, after going through the schematic of the prop assembly, I was missing a 'spacer'. It is after the prop and before the blocker cup. I got the part from Stevens for $6.50 and after installing it, no more slip. Thanks again doc and fishkisser.:flowered: