Undertaker
02-21-2009, 04:14 PM
Decided to change the fuel/water separator today and I'm glad I didn't have to find out the hard way (on the water) that it wasn't a very well thought out place to mount the unit.
2008 Thunderjet Luxor O/B, 20 ft.
Pic 1 is the view from the in-floor fish box. Note the cross member under the filter. Filter is partially unscrewed to show part numbers.
http://www.ifish.net/gallery/data/500/Fuelsep1.JPG
http://www.ifish.net/gallery/data/500/Fuelsep2.JPG
Pic 2 is an overhead shot to show the lineup of that cross member.
Without unscrewing one side of the filter mount and twisting to one side, there was not enough room to remove the filter as installed.
This is just a heads up for anyone that hasn't actually replaced their filter yet. I have always had a spare on board, but had no need to replace it until today.
2008 Thunderjet Luxor O/B, 20 ft.
Pic 1 is the view from the in-floor fish box. Note the cross member under the filter. Filter is partially unscrewed to show part numbers.
http://www.ifish.net/gallery/data/500/Fuelsep1.JPG
http://www.ifish.net/gallery/data/500/Fuelsep2.JPG
Pic 2 is an overhead shot to show the lineup of that cross member.
Without unscrewing one side of the filter mount and twisting to one side, there was not enough room to remove the filter as installed.
This is just a heads up for anyone that hasn't actually replaced their filter yet. I have always had a spare on board, but had no need to replace it until today.