Expalin the autoblender please.....

[EULACHON]

I had injected 2 strokes on my Northriver and am changing out the kicker to a new 4 stroke.

My boat has 2 oil tanks a small one for the kicker and a big one for the jet.

The line from the fuel tank goes to the left side of the water seperator and there is a line heading to starboard from the same side of the water seperator.

On the port side of the seperator there is one line that runs off and down to the starboard side and then the line for the kicker comes up and to the kicker.

I no nothing about the autoblend system but my question is can I just plumb off the port side of the fuel seperator??

I don't want to blow something up but I don't need a bunch of extra hoses either.

I assume the line on the port side is going to the small oil tank or??

What is confusing me is the 2 lines on the starboard side going one from the tank and the other looks like it going to the bulb on the big motor

A little help please.....

[FISHON67]

I know this isn't what your looking for, but it was alot of fun...:yay:
http://www.ifish.net/gallery/data/500/medium/Moto_Blender.jpg
Moto blender:laugh:

http://www.ifish.net/gallery/data/500/medium/Moto_blender_2.jpg
Blended drinks anyone?

:cheers:

[Boat Doc']

You should have a line from the tank to the water seperator then from the seperator to each motor. If you no longer need the oiler for the troller remove it. If the line from the seperator to the big motor goes thru the oiler leave it that way.